Step 4: Installing Anti-Tip Device - Thermador Professional PRO-HARMONY PRD30 Manuel D'installation

Grill/Griddle Tilt
Adjustment (Not All
Models)

Step 4: Installing Anti-Tip Device

Page 12
• Ensure that the burner caps are correctly seated on the burner bases of the
range's cooktop.
• Remove all tape and packaging before using the appliance. Destroy the pack-
aging after unpacking the appliance. Never allow children to play with packaging
material.
Important: DO NOT lift the range by the oven door handle, as this may damage the door hinges
and cause the door to fit incorrectly to the oven cavity.
If the range is equipped with an electric griddle or gas grill, check the grill/griddle
frame adjustment by pouring two tablespoons of water on the back of the griddle or
grill plate. The water should slowly roll into the grease tray. If not, adjust the two
screws under the back of the frame. Start with one half turn counterclockwise
(CCW) of the screws. Further adjustment should be made by one-quarter turn until
water slowly flows into the grease tray.
For 30" and 36" ranges, an anti-tip device must be installed as per these instruc-
tions.
WARNING - RANGE TIPPING HAZARD
• All ranges can tip and injury can result. To prevent accidental tip-
ping of the range, attach it to the floor, wall or cabinet by installing
the Anti-Tip Device supplied.
• A risk of tip-over may exist if the appliance is not installed in accor-
dance with these instructions.
• If the range is pulled away from the wall for cleaning, service or any
other reason, ensure that the Anti-Tip Device is properly reengaged
when the range is pushed back against the wall. In the event of
abnormal usage (such as a person standing, sitting, or leaning on
an open door), failure to take this precaution can result in tipping of
the range. Personal injury might result from spilled hot liquids or
from the range itself.
Range
Must be
Uniformly
Supported
by Braces
Provided
on Bottom
of Range
Figure 5: Dolly Positioning