Wiring Method - Rheem Classic Plus Série Manuel D'installation

5. 5. Wiring method

(1) Service cover removal
• Remove the two mounting screws.
• Remove the service cover by pushing downwards.
Direction of the service
panel removal
(2) Fasten the power supply cord and the connection cord to the conduit holder using the
lock nut.
(Open the knock out holes with the tool so as not to transform conduit plate if
necessary.)
(3) Connect the power supply cord and the connection cord to terminal.
(4) Fasten the power supply cord and connection cord with cord clamp.
Knockout hole
Connection cord
Hook
(3 places)
Service cover
Lock nut
Conduit plate
Power cord
24 type
18 type
(5)Be sure to seal the holes when applying the putty.
Place the cords side by side. (Do not overlap the cords.)
(6)Put the service cover and valve cover back after completion of the work.
Power cord
UNIT C connection cord
UNIT B connection cord
UNIT A connection cord
Power cord
UNIT B connection cord
UNIT A connection cord
En-10