Troubleshooting - Thetford SANICON Turbo 600 Mode D'emploi

Waste discharge pressure stops or decreases dramatically.
The pump operates, but no liquid is expelled.
The motor will not run.
How do I disassemble the system to check for an object lodged
in the pump?
Warranty
For defined warranty terms, review the one-page warranty statement - see www.thetford.com.
Please give Serial Number (located on the pump or manual sticker) for calls to customer service and warranty is-
NOTICE
sues.
www.thetford.com

Troubleshooting

Problem
■ Are the holding tanks empty?
■ With pump on, look for location where hose expansion
differs; check for obstruction at that point.
■ Turn the pump switch to the Off position:
■ To CHECK FOR OBSTRUCTION IN HOSE (
Visually check for foreign matter lodged in the hose
by running your hand along hose.
■ TO CHECK FOR OBSTRUCTION IN IMPELLER:
Refer to Obstruction Removal section.
■ Failure to clear a clog could cause damage to the pump,
which will void the warranty.
■ Are the holding tanks empty?
■ Check that the RV gate valves are open.
■ Pump may be clogged.
Make sure:
■ Pump is turned on.
■ RV battery is charged.
■ Circuit breaker/fuse is functioning.
■ Pump is receiving voltage.
■ Foreign object is not preventing impeller operation.
Refer to "Obstruction Removal" section on page 8.
9
Solution
Sani-Con Model 600 - Permanent Storage Mount
K2
):