Thetford SANICON Turbo 600 Mode D'emploi page 5

Connect Electrical
Wires should be covered to protect from foreign objects
AVIS
NOTICE AVISO ATTENTION CAUTION ATENCIÓN DANGER
! ! ! !
and water
ATTENTION ATTENTION ATTENTION
Ref. Description
4A
RV Power Source
4A.1 Power Source - Red Wire
4B Ground Lug / Chassis Ground or negative battery terminal
Wire Size
■ Wire size is dependent on the distance between the pump
and power source. Actual wire sizes should be calculated
according to installation. Refer to Fig. 3.
■ Excess wire can be cut to length.
Connect Electrical
1. Disconnect positive red wire to the RV battery
(K3)
2. Attach the switch box
3. Route and connect the black and blue switch box leads to
(K1.4)
the short black
supplied eletrical connectors. To seal heat shrink connectors,
heat the connectors after wires are connected. Connect
additional wiring if required.
4. Route the long black wire (negative)
(K1)
assembly to the battery's
to a ground lug on the RV, or to an OEM provided chassis
(4B)
ground .
5. Locate the power source (battery or other main power source)
where the electrical connection will be made.
(K3.1)
6. Route the red wire
(K4)
fuse holder .
www.thetford.com
4B
+
4A
4A.1
(4A)
inside RV compartment
(K1.5)
and blue pump leads using
(K1.6)
from the pump
(4A)
negative terminal, or
(K3)
from the switch box
K1.6
K4
BAT
AUX
K3
Fuse
Fig. 4
K3.1
Ref. Description
K1
Pump Assembly
K1.4
K1.5
K1.6
K3
Switch Box / Wiring
K3.1
K4 Fuse Holder / 35AMP Fuse
7. Crimp one end of the fuse holder to the red wire
attach the other end to the red wire
NOTICE
8. Attach the other end of the red wire
(4A)
source
9. Protect all the wiring for the Sani-Con® system with a wire
sheath (not provided).
.
10. Reconnect the red (positive) cable that was removed in step 1
of this procedure to the RV's battery.
(5D)
.
to the
5
K1.5
K1
K1.4
Pump Black Wire
Pump Blue Wire
Pump Black Wire - Negative (Long Wire)
Switch Box Red Wire
(4A.1)
(K4)
The fuse holder should be mounted within 18 " of
the power source.
(4A.1)
.
Sani-Con Model 600 - Permanent Storage Mount
(K3.1)
and
.
to the power