Thetford SaniCon Turbo 97601 Guide Rapide

Parts: K1 - K2
K2
K1
New Ref. Description
K1 K1 (1x) Rubber Coupling
K2 K2 (2x) Hose Clamps
NI A (1x) Pipe Hanger
(1x) A.1 Screw
NI B Pump
NI C Sewer Outlet
NI NOT INCLUDED - Reference only.
Tools Needed:
■ Screw Driver – Slot Head
■ Screw Driver – Phillips
Thetford Corporation recommends that only
AVISO AVIS
NOTICE ATTENTION ATENCIÓN DANGER CAUTION DANGER
! ! ! ! !
a trained and qualified technician service this
ATTENTION ATTENTION ATTENTION ATTENTION
product and plumbing and electrical work be
performed by a licensed tradesperson. Local
permit and code compliance is required.
Thetford Corporation accepts no responsibil-
ity or liability for damage to equipment, injury,
or death that may result from the system's
improper installation, service, or operation.
Questions?/Des questions?/¿Preguntas? 1-800-543-1219
P.O. Box 1285
Ann Arbor, MI 48106
www.thetford.com
Rubber Coupling Kit
A.1
A
PREPARE
■ Flush all debris from holding tanks.
■ Close all dump valves.
REMOVE PART
USE OLD PARTS:
REPLACE PART
USE NEW PARTS:
1
Part No.
N° de pièce
Pieza n.°
B
AVISO ATTENTION CAUTION ATENCIÓN DANGER AVIS
NOTICE
Be sure power has been disconnected before
! ! ! !
ATTENTION ATTENTION ATTENTION
you continue.
K2 A.1
1. Loosen (2x) and
K1 A, B
2. Remove from
K1 K2
3. Discard and .
Position K2 (2x).
1.
K1 A.
2. Slide through
B C K1
3. Insert and into
1.5".
A.1 K2
4. Tighten and (2x) to secure
B
5. Power up ; verify voltage at motor is 12v.
6. Use grey water to test for leaks.
Form/Formulaire n°/Formulario n.° 97639 Rev. B 04.25.17
97601
Made in the U.S.A.
Fabriqué aux É.-U.
Hecho en EE. UU
C
.
C
and .
so that each side is inserted about
K1
into place.