Festool DOMINO XL Guide D'utilisation page 12

5
5-1
13,5 mm
Use the adjusting lever [5-2] to adjust the width of
the dowel hole you intend to cut for an adequate fit
or set with 3 mm play:
Tight fitting dowel 13.5 mm + cutter diameter
Dowel with lateral 16.5 mm + cutter diameter
play
You can see on the display [5-1] what dowel hole
width is selected.
Setting the Mortise Depth
The mortising depth determines how deep into the
workpiece the mortising bit penetrates. This needs
to be adjusted for different sized tenons.
In most cases, the tenon should be centered across
the joint, and the depth of the mortise should be ½
the length of the tenon. However, in some cases you
may want to have more of the tenon in one piece
than the other. In this case, the sum of the two
depths must equal the length of the tenon.
WARNING
Cutter can come out at the rear side of the work-
piece.
Risk of injury
Set the routing depth at least 5 mm less than the

workpiece thickness.
Press one or two snap buttons [6-1].

Set the slide for the routing depth setting [6-2]

to the desired routing depth (15 - 70 mm).
Release the snap buttons [6-1].

 With the two markers [6-3], you can mark two
routing depths and switch easily between them
12
16,5 mm
5-2
using the slide [6-2](e.g. for asymmetric DOMI-
NO dowel depth distribution).
6
Changing tools
Different mortising bits are available for a variety of
Domino tenon sizes. The DF 700 EQ comes
equipped with a 12 mm bit, and 8, 10 and 14 mm
bits are available as an option.
WARNING
Risk of injury, electric shock
Always pull the mains plug out of the socket be-

fore performing any type of work on the ma-
chine!
CAUTION
Hot and sharp tools
Risk of injury
Wear protective gloves.

WARNING
Risk of injury
Never use dull or damaged mortising bits.

Only mortising bits provided by Festool for this

purpose may be mounted on the power tool.
Do not resharpen mortising bits more than

twice.
6-1
6-2
6-3