Installation Instructions - ZANKER KEI8440XXK Notice D'utilisation

Problem
and a number come on.
comes on.
If you tried the above solutions and cannot repair the
problem, speak to your dealer or the customer service.
Give the data from the rating plate, three digit letter
code for the glass ceramic (it is in the corner of the
glass surface) and an error message that comes on.

Installation instructions

Warning! Refer to "Safety information" chapter.
Before the installation
Before the installation of the appliance, record the infor-
mation below from the rating plate. The rating plate is
on the bottom of the appliance casing.
• Model ...........................
• PNC .............................
• Serial number ....................
Possible cause
There is an error in the appliance.
There is an error in the appliance
because a cookware boils dry. The
overheating protection for the
cooking zones and the Automatic
Switch Off operate.
Make sure, you operated the appliance correctly. If not
the servicing by a customer service technician or dealer
will not be free of charge, also during the warranty peri-
od. The instructions about the customer service and
conditions of guarantee are in the guarantee booklet.
Built-in appliances
• Only use the built-in appliances after you assemble
Connection cable
• The appliance is supplied with the connection cable.
• Replace the damaged mains cable with a special ca-
Disconnect the appliance from the
electrical supply for some time. Dis-
connect the fuse from the electrical
system of the house. Connect it
again. If
to the service centre.
Deactivate the appliance. Remove
the hot cookware. After, approxi-
mately 30 seconds, activate the
cooking zone again. If the cookware
was the problem, the error message
goes out of the display, but the re-
sidual heat indicator can stay. Let
the cookware become sufficiently
cool and refer to "Cookware for the
induction cooking zone" to see if
your cookware is compatible with
the appliance.
the appliance into correct built-in units and work sur-
faces that align to the standards.
ble (type H05BB-F Tmax 90°C; or higher). Speak to
your local Service Centre.
Remedy
comes on again, speak
25