Yamaha MusicCast YSP-5600 Guide De Référence Rapide page 8

1 2 3 4
Example for installing the unit
This unit outputs sound beam as shown in the illustrations below. Install this unit where there are no obstacles such as furniture obstructing the path of sound beams. Otherwise, the
desired surround sound effects may not be achieved.
If the unit is installed so that it is parallel to a wall, install it as close to the exact center of the wall as possible.
If the unit is installed in a corner of a room, position it at a 40–50° angle to the adjacent walls.
• See pages 13 to 15 in the Owner's Manual for additional installation examples.
Viewed from above
Sound beam output varies depending upon the 3D surround/Surround setting (pages 37
and 38 in the Owner's Manual) and the channel output setting (page 72 in the Owner's
Manual). The illustration above shows the path of sound beams when 3D surround is
enabled and "Front" in the Channel Out setting is set to "Beam".
8 a Installation
En
Parallel installation
Viewed from the side
Objects,
Sound beams
such as
are reflected off
furniture
the ceiling
Coner installation
Viewed from above
40° to 50°
Objects, such as
furniture
The illustrations above show the path of sound beams when 3D surround is enabled
(page 37 in the Owner's Manual) and "Front" in the Channel Out setting is set to "Stereo".
(page 72 in the Owner's Manual).
Viewed from the side
Sound beams
are reflected off
the ceiling