Connection To The Mains - Nordcap COLIBRI Mode D'emploi

7. CONNECTION TO THE MAINS

1 . Ensure that mains voltage and frequency are the same as those stated on the rating plate (A) attached
to the appliance. 2. Ensure that the supply socket has the following characteristics: a)
earthed. b) It fulfils the requirements of the rated current as set out on the rating plate.
the IEC regulations: - magnetothermal differential switch with In = nominal value as stated on the rating
plate; - Differential with Id sensitivity = 30 mA.
room. 4. The connecting cable to the appliance is H05 VVF, designed for internal use. For installation in
any other environment, it will be necessary to change the cable with the appropriate type (for example
H07 VVF for external use).
in a horizontal position or has been turned upside down, leave for at least three hours in the correct
position before switching on the power supply.
reduction adapters) (see figure5).
8. CONTROLS
The appliance features adjusting controls, protected on the front side.
switch on the refrigeration unit.
Thermostat: to adjust the temperature in the appliance.
temperature set-point, which can be changed by press button
9. CHECKING CORRECT OPERATION
Check that: 1. the appliance is plugged in.
is ON. 3. The thermometer shows the desired temperature for the goods to be stored.
not exposed to direct sunlight or high-powered lamps.
which the appliance is designed to work normally, i.e. +25°C, R.H.60% (climatic class 3).
that there are no direct air currents from doors, windows, ventilators or air conditioner pipes, inside the
appliance itself.
Operator's guide
3. Ensure that there is no danger of explosion (AD) in the
N.B. If during transport or storage the appliance has been placed by mistake
5. Connect the plug (do not use three-way adapters and
2. Thermometer: to display the temperature in the appliance.
2. The refrigeration unit is switched on and that the green light
7
1. Refrigeration unit switch:
a) Press button 3 "SET or P"
4 "UP" or button 5 "DOWN"
5. The room temperature does not exceed that in
it is properly
c) It complies with
to
once to display the
(see figure 6).
4. The appliance is
6.
Make sure
I
UK
D
E
F
NL
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO