Makita DRT50 Manuel D'instruction page 7

NOTICE:
If the tool is not secured after closing
the lock lever, tighten the hex nut, and then close
the lock lever.
1
► 1 . Hex nut
Adjusting cutting depth with the
plunge base
Optional accessory
1. Place the tool on the flat surface.
2. Select the stopper screw by rotating the stopper
base.
1
2
► 1 . Stopper screw 2. Stopper base
3. Loosen the stopper pole fixing nut, then pull up the
stopper pole while pressing the feed button.
1
2
3
► 1 . Stopper pole 2. Fixing nut 3. Feed button
4. Push down the tool until the tip of the trimmer bit
touches the flat surface, and then turn the fixing lever to
secure the tool.
1
► 1 . Fixing lever 2. Trimmer bit
5. Press down the stopper pole while pressing the
feed button until it contacts the stopper screw.
2
► 1 . Stopper pole 2. Stopper screw 3. Feed button
6. Slide the depth pointer so that the pointer indi-
cates "0" on the scale.
► 1 . Depth pointer
7. Adjust the cutting depth by pulling up the stopper
pole while pressing the feed button.
7 ENGLISH
2
1
3
1