Makita DRT50 Manuel D'instruction page 10

CAUTION:
When using the tool with the trim-
mer base, be sure to install the dust nozzle on the
trimmer base.
Installing or removing the tilt base
Optional accessory
1. Open the lock lever of the tilt base, then insert the
tool into the tilt base aligning the groove on the tool with
the protrusion on the tilt base.
► 1 . Lock lever
2. Close the lock lever.
To remove the base, follow the installation procedure
in reverse.
Installing or removing the offset
base
Optional accessory
1. Press the shaft lock, then loosen the collet nut.
1
2
► 1 . Shaft lock 2. Collet nut 3. Wrench
2. Remove the collet nut and the collet cone.
► 1 . Collet nut 2. Collet cone
3. Install the pulley on the tool by pressing the shaft
lock and tightening the pulley with the wrench.
1
► 1 . Wrench 2. Pulley 3. Shaft lock
4. Loosen the screws on the base plate, and then
remove the base plate.
3
► 1 . Base plate
5.
Open the lock lever of the offset base, then insert
the tool into the offset base.
10 ENGLISH
1
1
2
2
3
1