Bosch ISIO Notice Originale page 15

OBJ_BUCH-1714-002.book Page 15 Wednesday, July 31, 2013 11:47 AM
Sprayer
We declare under our sole responsibility that the product de-
scribed under "Technical Data" is in conformity with the fol-
lowing standards or standardization documents: EN 60745
(battery powered product) and EN 60335 (battery charger)
according to the provisions of the directives 2006/95/EC,
2004/108/EC, 2006/42/EC, 2011/65/EU.
Technical file (2006/42/EC, 2000/14/EC) at:
Bosch Lawn and Garden Ltd., PT-LG/ENS4,
Stowmarket, Suffolk IP14 1EY, England
Henk Becker Helmut Heinzelmann
Executive Vice President Head of Product Certification
Engineering PT/ETM9
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
17.07.2013
Mounting and Operation
Action
Delivery Scope
Battery Charging
Attaching Tool/Detaching Tool
Switching On and Off
Fitting Telescopic handle
Removing Telescopic handle
Adjusting Handle Length
Setting for Edge Cutting/Setting Handle Angle 8 – 9
Removing Wheels
Working Instruction Telescopic handle
Sprayer Application
Maintenance
Accessories
Troubleshooting
Problem
Cutting time per battery charge too low
Continuous lighting of the battery charge indicator
No charging procedure possible
Bosch Power Tools
Cutting Hedges
Before cutting check the hedge for foreign objects e. g. wire
fences.
Application
To maintain control hold the machine properly by the handle.
Holding the machine incorrectly could result in injury.
After use replace the blade transport guard.
Telescopic handle
The telescopic handle can be used with the grass and shrub
shear attachment. Before using the handle with the shrub
shear attachment, the wheels should be detached.
Anti Blocking
If the blade stalls on a tough material, the load of the motor in-
creases. The intelligent micro-electronics senses this over-
load condition and repeatedly reverses the motor, in order to
prevent stalling and to cut the material through.
This audible reversing cut action continues for up to 3 s.
Figure
After cutting through, the garden product continues in its nor-
mal mode, or in case the overload condition continues the
1
blades automatically stop in the open position (e. g. in case a
2
piece of metal fence accidentally blocks the garden product).
3
4
Battery Charge-control Indication
5
The battery charge-control indicator indicates the charging
6
progress. During the charging process, the indicator flashes
7
green. When the battery charge-control indicator lights up
green continuously, the battery is fully charged.
10
The battery charge-control indicator indicates the charge
condition of the battery for a few seconds when the On/Off
11 – 12
switch is pressed through halfway of fully.
13
LED
14
Continuous lighting, green
15
Flashing light, green
Flashing light, red
Continuous lighting, red
Possible Cause
Battery close to end of lifecycle
Battery pack defective
English | 15
Capacity
35 – 100%
15 – 35%
5 – 15%
0 – 5%
Corrective Action
Contact Service Agent
Contact Service Agent
F 016 L70 919 | (31.7.13)