Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
MANUAL OPERATION (COOL, DRY, HEAT)
To select the COOL, DRY or HEAT mode:
1
Press the
2
Select the operation mode by pressing the
Each time this button is pressed, the operation mode is changed in sequence:
(AUTO) →
To stop operation:
Press the
After the operation mode is set once, the operation starts in the same mode as
the one set previously from the next time by simply pressing the
When the set temperature is to be changed:
T
O
O
W
A
R
M
• Press the
button to lower the temperature. One press lowers the temperature by about 1°C.
T
O
O
C
O
O
L
• Press the
button to raise the temperature. One press raises the temperature by about 1°C.
In COOL operation
• When the outside temperature is low, the fan of the outdoor unit turns on and off frequently or decreases the rotation
speed to maintain sufÞ cient cooling capacity.
In DRY operation
• The temperature control (temperature setting) cannot be done.
• The room temperature is slightly lowered in this operation mode.
The details of the display on the indoor unit are explained on page 6.
If the air conditioner doesn't cool or heat effectively...
If the fan speed is set to Low or AUTO, sometimes the air conditioner may not cool or heat the air effectively. In this case,
change the fan speed to Med. or upper.
Change the fan speed.
Fan speed: Low or AUTO
O
N
O /
F F
button.
M
O
D
E
button.
(COOL) →
(DRY) →
(HEAT)
O
N
O /
F F
button.
Fan speed: Med. or upper
AIR FLOW VELOCITY AND DIRECTION ADJUSTMENT
AIR FLOW velocity and direction can be selected as required.
O
N
O /
F F
button.
To change the AIR FLOW velocity, press the
Each time the button is pressed, the fan speed is changed in sequence:
(Low)
(Med.)
(High)
(Super High)
• Use the
(Super High) notch to cool/heat the room more efÞ ciently.
• If the operating sound of the air conditioner disturbs your sleep, use the
(Low) notch.
To change the AIR FLOW blowing direction vertically, press the
V
A
N
E
button.
Each time the button is pressed, the angle of the horizontal vane is changed
in sequence:
(1)
(2)
(3)
(4)
SWING OPERATION
Use the swing operation for the air ß ow to reach all corners of the room.
Recommended horizontal vane range
for more efÞ cient air-conditioning
Use the
(AUTO) position usually.
Use position
(1) in the COOL or DRY mode and
use positions
(2) to
(4) in the HEAT mode when
adjusting to your requirements.
F
A
N
button.
(AUTO)
(SWING)
(AUTO)
C
O
O
L
1
D
R
Y
2
3
H
E
A
T
4
7
Publicité
Chapitres
Table des Matières
