Publicité
Les langues disponibles
Les langues disponibles
Tools Required
Philips head screwdriver.
Knuckle Mount (Figure 3.)
N
ote:
This configuration is equipped with an adjustable
knuckle which can be mounted directly to the 1/2"
NPS access hole in the cover plate of the junction
box.
1.
Loosen the knuckle center screw. Adjust the position of
the knuckle stem. Re-tighten.
2.
Route electrical leads through the 1/2" NPS access
hole in cover plate (supplied by others). Secure cover
plate to knuckle with lock nut. (65 in-lbs.)
N
ote:
Ensure wires do not get pinched.
N
ote:
Mounting the cover plate to the junction box and
then screwing the knuckle of the luminaire into the
cover plate can result in the twisting the wires,
causing connections to break and creating a shock
hazard when power is turned on.
3.
Use wire nuts or other approved connectors to wire
fixture per attached wiring diagram.
4.
Push wires into junction box and install cover plate
(with luminaire attached) to the junction box.
Figure 3.
Center Screw
Installation Instructions - NFFLD-S/UFLD-S
(+) Line
(-) Common
Ground
Figure 4.
Photocontrol – If Equipped (Figure 5.)
The orientation procedure is only required for
N
ote:
photocontrols which specifically require the cell to
be aimed north. Otherwise pre-selected factory
orientation will function properly. Follow the
directions recommended by the photocontrol supplier
for proximity to light sources. Lighted signs, building
surface reflection, floodlights, tree branches, etc.
may affect final position of the photocontrol.
1.
Using a flat blade screwdriver, loosen the two flathead
screws to allow rotation of the receptacle.
2.
Insert screwdriver into center slot and rotate receptacle
until arrow points north or desired direction.
3.
Retighten screws.
4.
Insert the photoelectric control (or shorting cap) into
receptacle and twist into locked position.
N
ote:
The photocontrol (not included) must contain a soft,
resilient gasket fastened to the bottom surface to
assure a proper weather seal between the control
and the receptacle.
Insert flat head
and rotate
Loosen screws
Figure 5.
EATON
IB506003EN
Black
White
Fixture
Green
Installation instructions
3
Publicité
