Cleaning And Lubricating The Drive Chain; Checking And Lubricating The Cables - Yamaha TT-R125 2009 Manuel Du Propriétaire

breakage. To prevent this from
occurring, keep the drive chain
slack within the specified limits.
[ECA10571]
1. Axle nut
2. Adjusting plate
3. Indicator
TIP
Make sure that both adjusting plates are
in the same position for proper wheel
alignment.
4. Tighten the axle nut to the
specified torque.
Tightening torque:
Axle nut:
60 Nm (6.0 m.kgf, 43 ft.lbf)
5. Adjust the brake pedal free play.
(See page 6-18.)
PERIODIC MAINTENANCE AND ADJUSTMENT
Cleaning and lubricating the
drive chain
The drive chain must be cleaned and
lubricated at the intervals specified in
the periodic maintenance and lubrication
chart, otherwise it will quickly wear out,
especially when riding in dusty or wet
areas. Service the drive chain as follows.
NOTICE
The drive chain must be lubricated
after washing the motorcycle and
riding in the rain.
1. Remove all dirt and mud from the
drive chain with a brush or cloth.
TIP
For a thorough cleaning, have a Yamaha
dealer remove the drive chain and soak
it in solvent.
2. Spray Yamaha Chain and Cable
Lube or a high-quality spray-type
drive chain lubricant on both sides
and on the middle of the chain,
making sure that all side plates and
rollers have been sufficiently oiled.
6 - 2 2
EAU23013
Checking and lubricating the
cables
The operation of all control cables and
the condition of the cables should be
checked before each ride, and the
cables and cable ends should be
lubricated if necessary. If a cable is
damaged or does not move smoothly,
have a Yamaha dealer check or replace
ECA10581
it. WARNING! Damage to the outer
sheath may interfere with proper
cable operation and will cause the
inner cable to rust. Replace a
damaged cable as soon as possible
to prevent unsafe conditions.
Recommended lubricant:
Engine oil
EAU23101
6
[EWA10721]