Onkyo BD-SP309 Mode D'emploi page 55

Network
Problem
Cannot connect to the
Internet.
Cannot download BD-
LIVE contents.
Other
Problem
The Player heats up
during use.
To Reset this Player
If this Player receives strong interference from a source such as excessive static electricity, strong
external noise, malfunction of power supply, or voltage caused by lightning during use or a wrong
operation is sent to the Player, errors like the Player not accepting an operation may occur.
• Press and hold ON/STANDBY on the Player until "RESET" appears on the front panel display when
the Player does not operate properly even after the power has been turned off.
• When a reset is performed while the power is on, the Player will turn off. Turn the power on again. At
this point, it may take a few moments for the system processing to ¿ nish before the Player is ready for
use.
• Since all settings including the language setting stored in memory are also reset when a reset has been
performed, they must be set again.
• When the problem persists even after performing a reset, unplug the AC cord and plug it in again. If this
does not solve the problem, contact the nearest service center approved by ONKYO SOUND & VISION
CORPORATION.
Possible causes and solutions
• Is the LAN cable connected properly?
• Is the wrong cable such as a modular cable used? Connect a LAN cable
to the ETHERNET terminal. (Page 18)
• Is the power for the connected equipment, such as a broadband router or
modem turned on?
• Is the broadband router and/or modem properly connected?
• Is the proper value(s) set in the network setting? Check "Communication
Setup". (Page 45)
• Is the LAN cable connected properly?
• Is the USB memory device properly connected? Check that the USB
memory device is connected to the USB (front) or USB (rear) terminal of
this Player.
• Check if the BD disc supports BD-LIVE.
• Check the setting for "BD Internet Access". (Page 44)
Possible causes and solutions
• When using this Player, the console cabinet may heat up depending on
the usage environment. This is not a malfunction.
ON/STANDBY
En
55