Before Starting Playback; Loading The Batteries In The Remote Control; Approximate Operating Range Of Remote Control; Connecting The Power Cord - Onkyo BD-SP309 Mode D'emploi

Before Starting Playback

Loading the Batteries in the
Remote Control
Hold in the tab on the battery cover and
1
pull the cover towards the direction of the
arrow.
Load the two "AA" size batteries (R-06
2
size, UM/SUM-3). Place batteries with their
terminals corresponding to the
indications in battery compartment.
Insert the smaller tab of the battery cover
3
into the opening 1, and press down on the
cover until it clicks in place 2.
WARNING
• Do not use or store batteries in direct sunlight
or other excessively hot place, such as inside a
car or near a heater. This can cause batteries to
leak, overheat, explode or catch ¿ re. It can also
reduce the life or performance of batteries.
NOTE
• Do not subject the remote control unit to shock,
water or excessive humidity.
• The remote control unit may not function if the
Player's remote sensor is in direct sunlight or any
other strong light.
• Incorrect use of batteries may cause them to
leak or burst. Read the battery warnings and use
the batteries properly.
• Do not mix old and new batteries, or mix different
brands.
• Remove the batteries if you will not use the
remote control unit for an extended period of
time.
Approximate operating range
of remote control
Remote control sensor
30º
and
Remote control unit

Connecting the Power Cord

Plug the supplied AC cord into the AC INLET
terminal on the rear of the Player (1). Then plug
into AC outlet (2).
NOTE
• Place the Player close to the AC outlet, and keep
the power plug within reach.
• TO PREVENT RISK OF ELECTRIC SHOCK,
DO NOT TOUCH THE UN-INSULATED PARTS
OF ANY CABLES WHILE THE AC CORD IS
CONNECTED.
• If you are not going to use this Player for a long
period of time, be sure to remove the AC cord
from the AC outlet.
Approx. 16 feet (5m)
15º
30º
15º
RC-825DV
En
19