Faults - GLW MC25 Mode D'emploi

FAULTS

When operating faults occur trouble-shooting depends on different fault conditions.
After recognizing the fault condition trouble-shooting can be carried out by the following points.
Fault condition 1
Cable cannot be inserted.
Fault condition 2
Crimping has not been completed.
Fault condition 3
Crimping is completed.
Cable cannot be pulled out.
Fault condition 4
Cable insulation is not completely removed.
Fault condition 5
The end sleeve is not separated from band.
Fault condition 6
Counter respectively mc 25 do not work.
Fault condition 7
The mc 25 works too slow but counter works.
Fault condition 8
Crimp stamp or crimp forging die is defective.
16 01/97