Installation The Unit - Kenwood DPX500BT Guide De Démarrage Rapide

Installation the Unit

Installing the trim plate
Attach Accessory 2 to the unit.
Installing the unit
Bend the tabs of the mounting sleeve
with a screwdriver or similar utensil
and attach it in place.
⁄
• Make sure that the unit is installed securely in
place. If the unit is unstable, it may malfunction (for
example, the sound may skip).
10 | Quick Start Guide
Installing in Japanese-Made Cars and
General Motors Cars
Install onto the car bracket using the screws
(commercially available).
The holes of the car bracket to use will differ
depending on the car model.
Accessory 2
!
• Use only the specified screws. Using wrong screws
might damage the unit.
Installing Toyota Cars
Install onto the car bracket using the screws
(commercially available).
Use the mounting holes (¦ in the illustration shown
below) that fit the car bracket.
Screws (M5 × 8 mm max.)
!
• Use only the specified screws. Using wrong screws
might damage the unit.
Car Bracket
Screws (M5 × 8 mm max.)
Car Bracket
Accessory 3
(Only for TOYOTA car)