Basic Connections - Kenwood CMOS-300 Mode D'emploi

Connections

Basic Connections

Navigation system/video monitor
(separately available)
Camera
Connect the camera to the camera connection cord.
Camera's cord length: 5 m (197 inch), Camera connection cord
length: 3 m (118 inch)
When the monitor does not have the
rearview camera input and switches the
input upon detection, connect to vehicle's
reverse lamp harness.
Engine key
Main fuse
+
–
Battery
CAUTION
・ If the engine key of your vehicle does not have the ACC position, branch the wire energized when the
engine key is ON and connect it to the accessory power cord.
・ Before proceeding to connections, make sure that the engine key is not inserted and disconnect the (-)
terminal of the battery to prevent the short-circuiting incident.
6
|
CMOS-300/CMOS-200
Connect to the rearview camera video input or to the
external video input of the video monitor.
Video cord: 1.5m (59.1 inch)
Camera connection cord
Switch unit (CMOS-300 only): 2 m (78.7 inch)
Accessory power
Fuse
(ACC)
GND
Reverse detection cord (purple/white): 10 cm
(3.94 inch)
REVERSE
Not used when connecting to a navigation system
or monitor with a dedicated rearview camera video
input.
ACC
Accessory cord (Red): 1 m (39.4 inch)
Connect to the ON-OFF switchable power supply. Do not
connect to a permanently ON power supply.
GND cord (Black): 1 m (39.4 inch)
Connect to a metallic part of vehicle (a part of chassis
connected to the negative side of power supply).
Power supply box
CAMERA
CAMERA
Power cord
Fuse (2A)
2A
2A