Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5
Troubleshooting
First check according to the following table if you can solve the problem on your own before contacting your authorised Royal dealer, Royal service partner
or appliance market.
WARNING:
Danger of injury! Never use a defective appliance! Always switch off the appliance and disconnect it from the mains before starting troubleshooting
Zchapter 3.3, „Switching off and retracting power cord".
Problem
The appliance will not
The power cord is not plugged in.
start.
The aplliance stops
The overheating protection has tripped (possibly due
suddenly.
to blocked suction channels, filters, or similar).
Electronic dust bag
The dust container is full.
change indicator
Nozzle, telescopic tube or suction hose are clogged. Remove the obstacle. If necessary, use a long wooden stick (e.g. a broom-
(Fig. 1/13) lights up.
The power setting does not suit the flooring.
The filter is dirty.
The results are un-
Bypass vent (Fig. 1/5) is open.
satisfactory in spite of
The attached nozzle does not suit the flooring.
the appliance work-
ing correctly.
The "carpet/hard floor" selector (Fig. 1/9) is in the
wrong position for the particular type of floor.
The appliance's
Sucked-in objects are obstructing the air stream.
noise is unusually
loud.
NOTE:
If you were unable to solve the problem following this table, contact the Royal customer service (Zpage 48, „International Service").
5.1 Accessories and Spare Parts
Item number
Contents
7000022
5 dust filter bags +
1 motor protection filter
7100005
1 hygienic exhaust filter
M203-4
1 Parquet brush
M208-8
1 Turbo brush
5.2 Sources
„
You can order accessories and spare parts
from: Contact data Zpage 48, „International
Service".
„
Further items are available from
http://www.dirtdevil.de
5.3 Recommendation
£
We recommend: Swirl
£
bags with MicroPor
filtration
“
“
Swirl
, MicroPor
and "Y50" are registered trade marks of a
company of the Melitta group and used with their permission.
5.4 Disposal
Dispose of the appliance in compli-
ance with the environmental protection
laws of your country. Electrical waste
may not be disposed of together with
domestic waste. Use local old-appliance col-
lection points instead.
The filters used are made from environment-
friendly materials. You may dispose of them in
your household waste.
Possible cause
6
Warranty
6.1 Conditions of warranty
We grant a warranty of 24 months from the
date of purchase for the distributed appliance.
Within this period we will either repair or re-
place the appliance or accessory (damages to
accessories do not automatically cause a re-
placement of the complete appliance) all de-
fects due to manufacturing or materials at no
cost. Damages due to inappropriate use (oper-
ation on wrong voltage or type of current, con-
necting to unsuitable power supplies, break-
age, etc.) are exempt from warranty, as are
normal wear and minor defects that only negli-
gibly influence the appliance's value or service-
ability. Intrusions by unauthorised parties and
the use of spare parts not supplied by Royal
Appliance invalidate the warranty. Consuma-
ble parts are not included in the warranty and
must be paid for! The warranty is only valid if
Y50 dust filter
the date of purchase has been acknowledged
by the dealer's stamp and signature on the war-
ranty card or if a copy of the invoice is included
with sent-in appliance. Warranty services do
not cause an extension of the warranty period,
nor do they constitute a new warranty!
Insert the plug into a mains socket and switch on the appliance Zchapter 3.1,
„Vacuum cleaning".
Switch the appliance off and pull the plug out of the socket.
Eliminate the cause of overheating (e.g. blocked suction channels,
filters, etc.). Wait for about 45 minutes. After the appliance has cooled off, you
may switch it on again.
Empty/clean the dust filter bag.
stick) to do this.
Set the power to the setting suggested for the flooring, Zchapter 3.2,
„Adjusting the suction power".
Change/clean the respective filter Zchapter 4.4, „Changing the motor
protection filter" or Zchapter 4.3, „Changing the hygienic exhaust filter".
Close (Fig. 1/5) bypass vent.
Fit the correct nozzle, Zchapter 2.3, „Using further nozzles (accessories)".
Set the "carpet/hard floor" selector (Fig. 1/9) to the correct position for the
type of floor, Zchapter 3.1, „Vacuum cleaning", step 5.
Remove the objects. If necessary, use a long wooden stick (e.g. a broom-
stick) to do this.
6.2 In case of a warranty claim
Send us the appliance with an empty dust filter
bag and a short description of the fault in print-
ed letters. Head your letter "warranty claim".
Send it to the following address, including the
warranty card or a copy of the purchase slip:
Contact
Service".
Troubleshooting
Solution
Zpage
data
48,
„International
15
Publicité
Table des Matières
