Maintenance; Scheduled Maintenance Table - Nilfisk SR 1601 Instructions D'utilisation

ENGLISH

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defined by the person in charge of the maintenance.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by Nilfisk Service Center.
This Manual contains the Scheduled Maintenance Table and describes only the easiest and most common maintenance
procedures.
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted
at any Service Center.
WARNING!
To perform maintenance procedures, turn off the machine, disconnect the batteries, engage the parking brake
and remove the ignition key.
Read carefully the instructions in the Safety chapter before performing any maintenance procedure.

SCHEDULED MAINTENANCE TABLE

NOTE
Maintenance intervals given are for average operating conditions. Machines used in severe operational environments
may require service more often.
Procedure
Battery fluid level check
Battery charging
Hydraulic oil level check
Parking brake check
Main and side broom cleaning
Dust control system water filter check and cleaning
(optional)
Hydraulic system oil cooler cleaning
Broom check and adjustment
Hopper dust filter check and cleaning ("A" method)
Skirt integrity, height and operation check
Hopper gasket integrity check
Check and cleaning of electric fan and main motor carbon
brush housing.
Steering wheel bearing and hydraulic piston lubrication
Tank hydraulic oil filter replacement
Pump hydraulic oil filter replacement
Hopper dust filter check and cleaning ("B" method)
Hopper dust filter check and cleaning ("C" method)
Hydraulic oil "recharge" filter replacement
Tank hydraulic oil change
(1) For the relevant procedure, refer to the Service Manual.
(2) Or more often in dusty areas.
(3) Change the hydraulic oil for the first time after 500 hours, then every year.
20
INSTRUCTIONS FOR USE
Upon delivery
SR 1601 - 33019318
Every
Every 30
Daily 150
hours
hours
(2)
(1) - (2)
(1)
(1)
(2)
revised 08/2018
Every Every
300 1,000
hours hours
(2)
(1)
(1) - (3)
01/2009