Care & Cleaning - Sage Nutri Juicer Plus BJE520 Guide Rapide

Care & Cleaning
Ensure the juicer is turned off by pressing the
ON / OFF button on the control panel to OFF.
Then switch the appliance off at the power
outlet and unplug the cord. Ensure the juicer
is correctly disassembled.
FOR EASIER CLEANING
• Clean as you go and avoid dried on juice or
pulp residue.
• Immediately after each use, rinse removable
parts in hot water to remove wet pulp. Allow parts
to air dry.
• To minimise cleaning, line the pulp container with
a plastic freezer bag to collect the pulp. Pulp can
then be used in other dishes or as compost for
the garden or discarded.
CLEANING THE MOTOR BASE
1. Wipe the motor base with a soft, damp cloth
then dry thoroughly.
2. Wipe any excess food particles from the
power cord.
Do not use abrasive scouring pads or cleaners
when cleaning the parts or motor base as they may
scratch the surface.
CLEANING THE FILTER BOWL
SURROUND, JUICER COVER,
FROOJIE INSERT, FOOD PUSHER,
®
PULP CONTAINER
1. Wash all parts in warm soapy water with a soft
cloth. Rinse and dry thoroughly.
The filter bowl surround, juicer cover and pulp
container are dishwasher safe (top shelf only).
The Froojie Insert is not dishwasher safe. Please
®
wash in warm water.
CLEANING THE JUICE JUG
1. Rinse the juice jug and lid with froth attachment
under running water.
2. Wash both parts in warm soapy water with
a soft cloth. Rinse and dry thoroughly.
• The juice jug and lid are dishwasher safe
(top shelf only).
• Discolouration of the plastic may occur
with strongly coloured fruit and vegetables. To
help prevent this, wash parts immediately after
use. If discolouration does occur, the plastic parts
can be soaked in water with 10% lemon juice or
they can be cleaned with a non abrasive cleaner.
10
WARNING
Do not immerse the motor base in water or
any other liquid. The centre of the juice disc
and feed chute contains small sharp blades
to process fruit and vegetables during the
juicing function. Do not touch blades when
handling the juice disc or feed chute.
CLEANING THE JUICE DISC
For consistent juicing results always ensure that
the juice disc is thoroughly cleaned using the
supplied cleaning brush.
1. Soak the juice disc in hot soapy water for
approximately 10 minutes immediately after
juicing is completed. If pulp is left to dry on
the filter it may clog the fine pores of the filter
mesh thereby lessening the effectiveness of
the juicer.
2. Using the cleaning brush, hold the juice disc
under running water and brush from the inside
of the basket to the outer rim. Avoid touching
the small sharp blades in the centre of the juice
disc. After cleaning the juice disc, hold it up
towards a light to ensure the fine mesh holes
are not blocked. If the holes are blocked, soak
the juice disc in hot water with 10% lemon juice
to loosen the blocked holes. Alternatively, wash
the juice disc in the dishwasher.
• The juice disc is dishwasher safe
(top shelf only).
• Do not soak the juice disc in bleach or other
abrasive cleansers.
• Always treat the juice disc with care as it can be
easily damaged.