Care & Cleaning - Sage The Big Squeeze SJS700 Guide Rapide

Care & Cleaning
Extract all the remaining pulp in the juicing bowl
before stopping the juicer.
For easier clean up, operate the juicer for
an additional 30 seconds after the juice is
extracted. Then fill the juicing bowl with water
and run the juicer before opening the drum lid.
When the drum lid is stuck, press the
REVERSE – OFF – FORWARD button in this
order, switching back and forth 2 to 3 times to
dislodge. Then place both hands on the drum
lid and firmly press down while simultaneously
turning the drum lid to open.
CLEANING THE JUICER
1. Switch OFF and unplug the power cord
from the wall outlet.
2. Turn the drum lid counter clockwise to open.
WARNING
When moving the appliance, do not lift by
grabbing the feeding tube. Always lift the
appliance by grabbing the body or handle.
3. Turn the top-set counter clockwise and lift
off the body.
10
4. Remove the juicing screw, strainer and
rotation wiper unit from the juicing bowl.
Clean with provided brush.
NOTE
Immediately clean the juicer after each use.
If remaining residue in the juicer dries up,
it can make disassembling and clean-up difficult.
The excess build up can cause poor performance
in future uses. For easier disassembly, place the
top-set in the sink and run the water through from
the top of the top-set.
We do not recommend to wash any parts of the
juicer in the dishwasher. Washing parts in the
dishwasher can cause damage to them due
to prolonged exposure to harsh detergents,
hot water and pressure.
5. Place the juicing bowl under running water
and unplug the compression silicone to clean
the pulp spout.
6. Under running water, clean the outside of the
juicing screw with a dish scrub. Use the tip of
the cleaning brush to push out any residue in
the crevices on the bottom of the juicing screw.
Thoroughly clean the juicing screw ensuring that
the juicing screw is clean without any residue.
Thoroughly dry the bottom of the juicing screw.
After juicing ingredients with seeds, make
sure to thoroughly clean the bottom crevice
of the juicing screw. (If this area isn't properly
cleaned, it can cause the part to be damaged).
7. Clean the body with a soft damp towel and dry.
If the towel is dripping wet, make sure to
squeeze out the excess liquid before using
it on the juicer.
CLEANING SILICONE PARTS
Clean the rotation wiper under running water.
Thoroughly dry after cleaning. Before assembling
the top-set, ensure that the compression silicone
and silicone ring are firmly inserted.
If the compression silicone and silicone ring
are not firmly inserted, juice may leak from the
bottom of the juicing bowl.
COMPRESSION SILICONE
Unplug to clean.
After cleaning, firmly insert into the slot below
the pulp spout.
SILICONE RING
Remove the silicone ring from the juicing
bowl to clean.
After cleaning, push in the silicone ring with the
smaller surface facing down.
SMART CAP
Remove from the juice spout to clean.
After cleaning, attach the smart cap to the
smart cap silicone on the juice spout.
EN
11