Beurer WL 32 Mode D'emploi page 6

Shutting off the alarm
When the alarm sounds, press the AL 1-2 button. The alarm is now canceled and will sound again the next day.
Permanently deactivating the alarm
To deactivate Alarm 1, press the AL 1-2 button once. To deactivate Alarm 2, press the AL 1-2 button twice.
Now press the SET/MEM button until the note icon (
ber 1 or 2 on the LCD Display. Press the AL 1-2 button to confirm.
Snooze function
When an alarm sounds, press down on the light dome to activate the Zz button and temporarily suspend
the sound. The alarm will sound again once the preset snooze duration elapses. To set the desired snooze
duration, see the "Setting the time and the snooze duration" section.
Sunrise function
After setting an alarm, you can also wake up to a simulated sunrise in which the LED light gradually becomes
brighter.
NOTE: For this function to work, you must use the Power Adapter provided.
1. Press and hold the Zz button for about five seconds; "15" will flash on the LCD Display.
2. Press the ▲/▼buttons to set the desired simulated sunrise start to 15 or 30 minutes before the alarm time.
To shut off the sunrise simulation, set the value to OFF; the lamp symbol (
the time on the LCD Display. Press the Zz button to confirm and exit.
Lamp function/mood light
The wake-up light can also be used as a normal lamp or as a color-changing mood light.
NOTE: The mood light function only works when the Power Adapter is connected. When listening to the radio
or using the Sleep function, the mood light function is deactivated. When listen radio, you have to
turn on light before! When only use with batteries, then white light goes off after 5 seconds.
1. Press the Zz button; the LED light illuminates dimly.
2. To activate the lamp function, press the Zz button again e.g.; "L 09" will flash on the LCD Display, indi-
cating brightness level 9.
3. Press the ▲/▼ buttons to set the desired brightness level from 0-15.
4. To activate the mood light, press the Zz button again; the mood light will illuminate and change colors.
5. To set a particular color, press the Zz button again.
6. To shut off all light functions, press the Zz button again.
Listening to the radio
1. Uncoil the flexible wire antenna on the rear of the device and extend it fully for best reception.
2. Press the radio button to switch the radio on; "ON" will flash on the LCD Display for about 10 seconds
and then the set radio frequency will display.
3. Press the ▲/▼ buttons to set the desired frequency.
4. To search for a radio station, press either of the ▲/▼ buttons. The search will start in the selected direction
and will stop when a radio station is found.
5. To change the volume, press the Volume button, then press the ▲/▼ buttons as needed.
6. To shut the radio off, press down on the dome of the lamp (activate zZ button).
NOTE: When listening to the radio, the mood light function is deactivated.
Storing radio stations
You can store up to 10 radio stations.
1. Press the Sleep Function / Radio button to switch the radio on.
2. Use the ▲/▼ buttons to tune to the radio station you would like to store.
3. Press and hold the SET/MEM button for about two seconds; "01" (the memory number) will flash on the
LCD Display below the frequency.
) and bell icon ( ) disappear from next to the num-
6
) will disappear from above