Threading The Machine - ELNA eXplore 320 Mode D'emploi

z

Threading the Machine

To set the needle thread:
Raise the thread take-up lever to the highest position by
turning the handwheel.
Raise the presser foot.
WARNING:
Turn OFF the power switch before threading the needle.
Draw the thread from the spool and pass it under the
1
thread guide. Then draw it down along the right
channel.
1
Thread guide
2
Right channel
Draw the thread up around the bottom of the thread
2
guide plate.
Pull the thread up along the left channel
3
Thread guide plate
4
Left channel
Firmly draw the thread from right to left over the
3
thread take-up lever and down into the take-up lever
eye.
5
Thread take-up lever
Draw the thread down along the left channel and slip
4
the thread behind the needle bar thread guide from
the left.
6
Needle bar thread guide
Pass the thread through the needle eye from the front
5
or use the needle threader (refer to the next page).
30