Milwaukee 0613-20 Manuel De L'utilisateur page 6

WARNING!
Charge only MILWAUKEE 12, 14.4
and 18 Volt battery packs in charg-
ers. Other types of batteries may
explode causing personal injury
and damage.
Charge your battery pack before you use
your tool for the first time and when your
tool no longer performs with the power
and torque needed for the job. Never
completely discharge the battery pack.
Standard charging time will vary accord-
ing to the type of charger you use. The
charging time will also vary depending on
the supply voltage and charge needed. For
example, if your battery pack does not
require a full charge, charging time will be
less.
FOR SPECIFIC CHARGING INSTRUCTIONS,
PLEASE READ
OPERATOR'S MANUAL SUPPLIED WITH
YOUR CHARGER.
Battery packs are affected by tempera-
ture. Your battery pack will perform best
and have longest life if it is charged when
the temperature is between 60°-80°F (15°-
27°C). Do not charge in temperatures be-
low 40°F (5°C) or above 105°F (40°C).
Under these conditions, capacity will be
reduced. (See "Maintenance").
CHARGING & USING BATTERY PACKS
THE CHARGER
Inserting Battery Pack into Tool
(Fig. 1 & 2)
Battery pack can be inserted into the tool
in two ways.
Fig. 1
1. For working in restricted spaces.
Insert the battery pack from the front
by sliding battery pack into the body of
the tool. Insert the battery pack until
the battery latches lock.
Fig. 2
2. For optimum weight distribution and
balance.
Insert the battery pack from the back
by sliding the battery pack into the body
of the tool. Insert the battery pack until
the battery latches lock.
3. To remove the battery pack, press in
both battery latches and slide the bat-
tery pack off of the tool.
6