Panasonic ES8092 Manuel D'utilisation page 7

2. Remove the screw (a) and the
panel cover (b).
3. Remove the two screw covers (c)
(using something like a tooth-
pick), and 6 screws (d).
4. Remove the back panel (e).
5. Lift the battery block (f) and re-
move it from the battery terminal
sealing (g).
6. Remove the batteries from the
battery block (h).
WARNING:
Do not attempt to replace the bat-
teries for the purpose of reusing
the shaver. This could result in the
risk of fire or electric shock.
Caution
• Do not charge the shaver where the
temperature is below 0°C (32°F) or
above 40°C (104°F), where it will
be exposed to direct sunlight or a
heat source, or where there is a lot
of moisture.
• Use only the included shaver
charging adaptor RE7-01 to charge
the ES8092/ES8094/ES8095
shaver.
• The supply cord of the charging
adaptor cannot be replaced; if the
cord is damaged, the entire charger
should be discarded.
• Dry the shaver completely before
setting it in the charging adaptor.
• Keep the charging adaptor away
from water and handle it only with
dry hands. Do not use an extension
cord to connect the charging adap-
tor to an outlet.
• The shaver may not immediately
begin to charge after being placed
into the charging adaptor after use.
Allow the shaver to sit in the charg-
ing adaptor for a few minutes and
check again to make sure that it is
being charged.
• Do not place any metal objects like
coins and paper clips on the charg-
ing adaptor as they will become
warm.
• Grip the plug when disconnecting
the charging adaptor from a recep-
tacle; tugging on the cord may dam-
age it.
• Store the charging adaptor and its
cord set in a dry area where it will
be protected from damage.
• The linear motor of the shaver may
start operating without the On/Off
switch on if the shaver is placed
near a television, stereo, audio-
visual equipment or anything that
generates strong magnetic field.
Do not place the shaver near these
equipments.
• The outer foil is very thin. If han-
dled improperly, it can be easily
damaged. To avoid personal injury,
do not use the shaver if it has a
damaged foil or inner blade.
• Wash the shaver in tap water. Do
not use salt water or boiling water.
Also, do not use cleaning products
that are designed for toilets, bath-
rooms or kitchen appliances. Do
not submerge the shaver for a long
time.
• Do not wipe any part of the shaver
with thinner, benzine or alcohol.
Clean it by using a cloth dampened
with soapy water.
10
10
• Do not take the housing apart as
this can affect the watertight con-
struction.
• Do not shave when the "sonic" vi-
bration is activated, as it may dam-
age your skin.
Specifications
Power source: 100-240V AC,
50-60 Hz (Automatic voltage conver-
sion)
Motor voltage: 2.4 V DC
Charging time: 1 hour
This product is intended for house-
hold use only.
READ ALL INSTRUCTIONS BE-
FORE USE.
FOR YOUR CONVENIENCE, WE HAVE ESTABLISHED A TOLL-FREE
(IN USA ONLY) NATIONAL ACCESSORY PURCHASE HOT LINE AT
1-800-338-0552.
FOR CANADA, PLEASE CONTACT ONE OF THE SALES BRANCHES
MENTIONED ON THE BACK PAGE.
11
11