Wireless Connection; General Instructions; Electrical Connection - Thomas CentraClean 15-301 Instructions D'installation Et De Service

3.0 Electrical connections
The system may be operated either by radio, control cable or a combination of radio and control cable.
Depending on the required mode of operation, the following steps have to be taken.

3.1 Wireless connection

( = central vacuum unit without power control / = central vacuum unit with
power control)

3.1.1 General instructions

When operating by radio you can teach-in up to 16 sensors and/or repeaters. Should the 17 sender be taught in
th
this will lead to the overwriting of the 16 sender.
th
Teaching in the sender should be carried out on the floor before the system is mounted.
The LCD display shows the mode of operation and the already previously run working hours as basic display (in new
{
status 000h ).
In learn and delete mode the system and status information will also be shown.
By turning off the main switch all activated learn and delete functions are interrupted but can be started again if
necessary.
3.1.2 Assembly information for central vacuum unit with power control
Install the receiver unit with at least 1 m distance to the hood of the system on the wall next. To do this,fix the base
plate of the receiver unit in the required position with four screws and screw the lid on the housing (see fig.). Connect
the receiver unit and hood using the external connection cable.
min. 1 m
I

3.2 Electrical connection

0
– Insert the mains plug of the connecting cable into the
Schuko plug socket provided by the customer (230 V, 16 A)
– Turn main switch to I.
13