Reading (X) And Resetting (Z) Of Sales Totals - Sharp XE-A301 Manuel D'instructions

A301_4(En) 03.4.24 7:42 PM
READING (X) AND RESETTING (Z)
OF SALES TOTALS
• Use the reading function (X) when you need to take a reading of sales information entered since the last reset.
You can take this reading any number of times. It does not affect the register's memory.
• Use the resetting function (Z) when you need to clear the register's memory. Resetting prints all sales
information and clears the entire memory except for the GT1 through GT3, Training GT, reset count, and
consecutive number.
Summary of Reading (X) and Resetting (Z) Reports
1
X1 and Z1 reports: Daily sales reports
X2 and Z2 reports: Periodic (monthly) consolidation reports
When you take an X or Z report, turn the mode switch to the appropriate position referring to the column of
"Mode switch position" shown on the table below, and use the following corresponding key sequence.
Mode switch position
Item
OPX/Z
Flash report:
(Only display)
To clear the
display, press the
l
key or turn the
mode switch to
X
another position.
Full sales report
--
Department report
--
Individual group
--
total report on
department
Full group total
--
report on
department
PLU report by
designated range
--
PLU report by
--
associated
department
Transaction report
--
58
Page 58
X1/Z1 X2/Z2
Dept. code
For dept. 1 to 20;
For dept. 21 to 40;
-- --
@
key: Amount of cash in drawer
A
key: Sales total
A
X1, Z1 X2, Z2 Reading:
d
X1 X2 Reading:
Reading: Group number
X1 X2
0
Reading:
X1 X2
Reading:
X2, Z2
X1, Z1
Resetting:
Start
PLU code
X1 X2 Reading: Associated dept. code
1
X1 X2 Reading:
Key operation
d
: Department sales total
¡
Dept. key ( to
D
Dept. key (
P
Resetting:
d
@
d
@
All PLUs
Start End
@
PLU code PLU code
All PLUs
End
@
PLU code
D
A
π
)
¡ π
to )
A
p
P p
p