Reading And Resetting Of Sales - Sharp XE-A101 Manuel D'instructions

Other Features for Sales Entries
• Correction of earlier entries (indirect void)
With this function, you can correct department or PLU entry incorrectly made during a transaction
if you find it before finalizing the transaction by pressing t, R or C.
To correct 3P entry to 4P after another correct entry has been made, enter the
Example
following:
3P 1150! 3vP 4P t
• Correction after issuance of receipt
This function allows you to reverse the entries made on an incorrect receipt. The entries are
subtracted from each totalizer and add to a void totalizer. Slide the mode switch to
and enter the same details that are on the incorrect receipt. (If necessary, enter the secret code
and press t when you slide the mode switch to

Reading and Resetting of Sales

All the data on all of your registrations as well as other transaction information will remain in the
memory of your cash register as long as your cash register has power (Be sure you have live
batteries installed in case of a power failure). This information can be printed in the form of a
report which can be helpful to you in running your business.
X reports for reading of sales
This report, when taken in the X/F mode, prints the accumulated information of sales.
Taking an X report is a good way to do a mid-day check on daily sales. You can take X reports any
number of times, because they do not affect the cash register's memory.
To issue an X report, set the mode switch to the X/F position and press t.
Z reports for reading and resetting of sales
This report, when taken in the Z/PGM mode, prints the same information as an X report. Once this
report had been printed, the cash register's memory of daily information is cleared and all the
transaction totals are reset to zero. Be sure to issue a Z report at the end of each day.
With a Z report printing, you can also reset GT (ground total).
To issue a Z report, follow the procedure described below.
1. Set the mode switch to the Z/PGM position.
2. If necessary, enter the secret code and press t.
To issue a Z report with resetting of GT:
3. Press C.
4. If necessary, enter the secret code and press C.
To issue a Z report without resetting of GT:
3. Press t.
4. If necessary, enter the secret code and press t.
12
Indirect void correct
3P
for entry
position.)
position,