Baby Unit; Parent Unit; Getting Your Baby Monitor Ready - Philips SCD463 Mode D'emploi

Baby unit

The baby unit can be mains or battery operated.
When batteries are installed, you have an automatic back up in
case of mains failure.
Mains operated use
1 Connect the power adapter cord to the power supply jack
(DC 9V — — < < + + - A-2) of the baby unit.
2 Connect the AC power adapter (A-3) to a wall outlet.
The baby unit is now ready for mains operated use.
Battery operated use
1 Remove the battery compartment cover (A-9) of the baby
unit, using a coin.
2 Insert four 1,5V AA batteries, noting the + and –
configuration inside the battery compartment (batteries are
not supplied, we recommend Philips Alkaline batteries).
3 Close the battery compartment cover (A-9), using a coin.
The baby unit is now ready for battery operated use.

Parent unit

The parent unit can be mains or battery operated.
When batteries are installed, you have an automatic back up in
case of mains failure.
Mains operated use
1 Connect the power adapter cord to the power supply jack
(DC 9V — — < < + + - B-5) of the parent unit.
2 Connect the AC power adapter (B-3) to a wall outlet.
The parent unit is now ready for mains operated use.

Getting your baby monitor ready

EN
7