Makita DUR187U Manuel D'instruction page 10

2. Place handle between handle clamp and handle
holder. Adjust the handle to an angle that provides a
comfortable working position and then secure with hex
socket head bolts.
1
► 1. Hex socket head bolt 2. Handle clamp
Mounting the attachment pipe
For DUR188U and DUR188L only
Mount the attachment pipe to the power unit.
1. Turn the lever to the direction of the arrow shown
in the figure.
► 1. Lever
2. Pull up the joint cover and insert the attachment
pipe while aligning the protrusion on the pipe (cutting
tool side) with the concave portion of the joint part.
1
► 1. Lock lever 2. Joint cover 3. Pipe
Make sure that the surface of the lock lever is parallel
to the pipe.
2
1
2
3
10 ENGLISH
3. Turn the lever to the direction of the arrow shown
in the figure.
► 1. Lever
To remove the pipe, turn the lever to the direction of the
arrow shown in the figure and pull the pipe out while
pressing down the lock lever.
1
► 1. Lever 2. Lock lever 3. Pipe
Installing the guard
WARNING:
Never use the tool without the
guard illustrated in place. Failure to do so can
cause serious personal injury.
CAUTION:
Take care not to injure yourself on
the cutter for cutting the nylon cord.
1.
Align the projections on the protector with the
grooves of the motor housing.
1
3
► 1. Protector 2. Groove 3. Projection
1
2
3
2