Before Installing This Unit; Installation With The Holder - Pioneer AVH-X5500BT Manuel D'installation

Section
01 Connecting the units
02
iPod with 30-pin connector
When connecting with optional
CD-IU201V cable
USB/iPod input
This product
AUX input
(AUX)
iPod with video
capabilities
(sold separately)
Dock connector
1.5 m
USB cable
(Supplied with this unit)
Connect to separately sold
USB device.
Interface cable
(CD-IU201V) (sold separately)
6
En
When connecting with optional
CD-IU201S cable
USB/iPod input
This product
RGB input
iPod with video
capabilities
(sold separately)
Dock connector
1.5 m
USB cable
(Supplied with this unit)
Connect to separately sold
USB device.
Interface cable
(CD-IU201S) (sold separately)
Installation
Notes
! Check all connections and systems before
final installation.
! Do not use unauthorized parts as this may
cause malfunctions.
! Consult your dealer if installation requires
drilling of holes or other modifications to the
vehicle.
! Do not install this unit where:
— it may interfere with operation of the vehicle.
— it may cause injury to a passenger as a result
of a sudden stop.
! Do not install the display where it may (i) ob-
struct the driver's vision, (ii) impair the per-
formance of any of the vehicle's operating
systems or safety features, including air
bags, hazard lamp buttons or (iii) impair the
driver's ability to safely operate the vehicle.
! The semiconductor laser will be damaged if
it overheats. Install this unit away from hot
places such as near the heater outlet.
! Optimum performance is obtained when the
unit is installed at an angle of less than 30°.
! When installing, to ensure proper heat dis-
persal when using this unit, make sure you
leave ample space behind the rear panel and
wrap any loose cables so they are not block-
ing the vents.
Leave ample
5 cm
space
5 cm
5cm cm

Before installing this unit

% Remove the holder.
1
1 Holder
(factory-supplied part)

Installation with the holder

1 Install the holder into the dashboard.
After inserting the holder into the dashboard, se-
lect and bend the tabs appropriate to the thick-
ness of the dashboard material. (Install this unit
as firmly as possible using the top and bottom
tabs. To secure this unit, bend the tabs 90 de-
grees.)