Cillit Impulsor Optronic F 3 Instructions De Montage Et D'utilisation page 17

T T T T T roub roub roub leshooting leshooting
roub roubleshooting leshooting leshooting
F F F F F ault ault ault
ault ault
Unit does not meter
appears on display (6 6 6 6 6 ) and
audio signal is emitted.
appears on display (6 6 6 6 6 )
appears on display (6 6 6 6 6 )
appears on display (6 6 6 6 6 )
If the fault cannot be rectified by following the above instructions, contact a specialist or our after If the fault cannot be rectified by following the above instructions, contact a specialist or our after If the fault cannot be rectified by following the above instructions, contact a specialist or our after If the fault cannot be rectified by following the above instructions, contact a specialist or our after If the fault cannot be rectified by following the above instructions, contact a specialist or our after
sales service. sales service. sales service.
sales service. sales service.
Cause Cause Cause Cause Cause
Connection piece is installed
against the direction of flow.
Active substance container
empty.
EMERGENCY STOP function fault.
Motor or drive is defective.
Motor controller is defective.
Cam echo sensor is defective,
positioned incorrectly
or the magnet is defective
Action Action
Action Action Action
Install the connection piece in
the direction of flow.
Connect a new active sub-
stance container (see Initial
startup).
Replace the electronic control-
ler.
Replace the motor and drive.
Replace the electronic control-
ler.
Replace the cam echo sensor.
Correct the position.
Replace the cam.
GB GB GB GB GB
1 7 1 7 1 7
1 7 1 7