vivocare Checky Mode D'emploi page 33

This section includes a list of error messages and frequently asked questions for
problems you may encounter with your blood pressure monitor. If the products not
operating as you think it should, check here before arranging for servicing.
PROBLEM SYMPTOM
Display is dim or
No power
will not light up.
Low
batteries
Show on the display
E 1 shows
E 2 shows
E 3 shows
E 10 or
Error
E 11 shows
massage
E 20 or
E 21 shows
EExx,shows on
the display.
CHECK THIS
Batteries are exhausted.
Batteries are inserted
incorrectly.
Batteries are low.
The cuff is not secure.
The cuff is very tight.
The pressure of the cuff
is excessive.
The monitor detected
motion while measuring.
Measure incorrectly.
System error.
33
REMEDY
Replace with new batteries
Insert the batteries
correctly
Replace with new batteries
Refasten the cuff and then
measure again.
Refasten the cuff and then
measure again.
Relax for a moment and then
measure again.
Movement can affect the
accuracy of measurement.
Relax for a moment and then
measure again.
Relax for a moment and then
measure again.
Retake the measurement.If
the problem persists, contact
the retailer or our customer
service department for further
assistance.Refer to the
warranty for contact
information and return
instructions.