Technical Specifications - Velleman CS250 Mode D'emploi

The detector drifts out of tune

The metal detector can be affected by changing temperatures e.g. when the device is taken out of
storage and out into the field. Wait a while until the temperature of your metal detector has
stabilised. The device may need as much as half an hour to acclimatise if the change in temperature
is extreme.

Sometimes batteries will cause the signal to drift. Replace them if this is the case.
13.

Technical Specifications

power supply
motion search modes
sensitivity adjustment
sensitivity
multitone indication
signal strength indication
LCD dimensions
volume adjustment
low battery indication
search coil size
operating temperature range
storage temperature range
options
alkaline 9 V batteries
accessory pack
Use this device with original accessories only. Velleman nv cannot be held responsible in the
event of damage or injury resulting from (incorrect) use of this device. For more info
concerning this product and the latest version of this manual, please visit our website
www.velleman.eu. The information in this manual is subject to change without prior notice.
R&TTE Declaration of Conformity
Hereby, Velleman NV declares that the radio equipment type [CS250] is in compliance with Directive
1999/5/EC.
The full text of the EU declaration of conformity is available at the following internet address:
www.velleman.eu.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part
of this manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise
without the prior written consent of the copyright holder.
V. 01 – 21/09/2015
CS250
2 x 9 V battery (not incl.)
all metal, discriminate, notch
8 levels
± 22 cm (depends of type of material)
3 tones
8 segments
47 x 76 mm
yes
yes
Ø 24 cm
0 °C to 40 °C
-20 °C to 60 °C
reference code 6LR61C
reference code CMDSET
10 ©Velleman nv