Gallagher SmartPower BX1500 Notice D'installation page 8

Installa on Guide
Step 3: Connect the fence
a) Connect the energizer's red Output ( ) terminal to the fence using Underground Cable (G6270).
b) A ach the other end of the cable to the fence using a Joint Clamp (G6030).
For instruc ons on fence installa on see the Gallagher Power Fence™ Manual enclosed.
Note: If you wish to use the Fence Voltage informa on see the sec on "Understanding your SmartPower
Energizer: Fence Voltage and Alarm".
Step 4: Turn the Energizer on
a) Plug the energizer into a power outlet and switch ON.
b) Allow at least 15 pulses for the energizer to adapt to the fence system.
Note: Readings will change as your SmartPower Energizer responds to fence condi ons.
This is the energizer monitoring the fence and adap ng its power output accordingly.
Read the sec ons "Understanding your SmartPower Energizer" pages 7-8 for a complete understanding of the
displays and alarms.
We recommend the earth system is tested a er installa on as per the "Earth Test" in the "Earth Voltage and Alarm"
sec on (pg 8).
Installa on Error
If the Output and Earth terminals have been connected the wrong way around the energizer will display the reading E7. If
this occurs re-connect the terminals correctly.
Keep the Quick Reference Help Guide beside your energizer.
+ -
For Mains Operation with Battery Back-up and for Battery Only Operation
:
IMPORTANT
ba ery leads into the back of the energizer before moun ng the energizer. The red lead must be next to the (+)
symbol and the black lead next to the (-) symbol on the back of the energizer.
Step 1: Install the Energizer, connect to earth and fence
Follow Steps 1-3 described on the previous page.
Step 2: Connect the ba ery
Connect the ba ery leads from the energizer to the ba ery: red lead to the (+) terminal of ba ery, black lead to the (-)
terminal of ba ery. If connec ng more than one ba ery, connect the ba eries in parallel.
Only use a 12V ba ery which is suited to back-up or cyclic applica ons (eg. G51700). The recommended type is a 12V deep
cycle lead acid rechargeable ba ery.
:
IMPORTANT
from the mains before connec ng or disconnec ng the ba ery.
+ -
For mains opera on with ba ery back-up:
Follow Step 4 (Turn the energizer on): described above. When connected to mains power, the energizer trickle charges the
ba ery. In the event of mains power failure, the energizer will automa cally switch to ba ery back-up and con nue to
power the fence.
+ -
For ba ery only opera on:
Follow Step 4 (Turn the energizer on): from Step b) described above.
For more informa on about opera ng SmartPower with a ba ery, see "Ba ery Use" sec on (pg 10).
8
To connect the ba ery, you will need to use the Gallagher MBX Ba ery Lead (G57400). Plug the
When you connect up the ba ery, the energizer will start working. Ensure energizer is turned OFF
Gallagher 3E0795 BX / MBX User Manual