Controller Functions - Carrera RC Rock Crawler 100011 Mode D'emploi

Let's practise!
1
POWER
DRIVE
2
• Never run more than 2 batteries down one after the other. After running down
two fully-charged batteries, a pause in running for at least 20 minutes is
essential.
• Avoid constant motor operation.
• If the car switches itself off several times one after another, the battery is dead.
Please recharge the battery.
• To switch off after use, follow the steps in the reverse order.
• After use, remove or disconnect the battery.
• Clean the Carrera RC car after use.
Troubleshooting
Problem Cause
Either the switch on the controller or the car is set to OFF.
Car does not move
There is no rechargeable battery in the car or the battery is too weak.
The car has come to a stop at an obstacle.
The battery or rechargeable battery in the transmitter or model is too
weak.
Different channel set up for car and controls.
The vehicle is very warm.
Vehicle starts moving unintentionally.
Car cannot be controlled
Transmitter antenna is defective.
Another RC model is using the same frequency.
Should you need spare parts, you will find a complete list of the available parts under carrera-rc.com in the service area.
Errors and changes excepted
Colours / final design – changes excepted
Technical changes and design-related changes excepted
Pictograms = symbolic photos
Warning: this vehicle is capable of
reaching high speeds. Practice on an
empty surface at least 4 metres (13')
square. When first starting, be very
careful when operating the gas pedal,
as the car reacts very quickly. Practice
running slowly for at least two to three
full charges of the battery before you
start practising faster manoeuvres.
Now it's time to practise! Set up a Car-
rera RC vehicle racing track in a large
empty area, using cornerposts, empty
cans, or similar objects. The basic tech-
nique to adopt when operating a Carrera
RC is to drive fast on the straight sec-
tions and to slow down in the curves.

Controller functions

1
ON
OFF
2
3
4
Solution
Switch on.
Insert charged battery.
The voltage surge protector has switched the car off.
Turn the ON/OFF switch on the car to OFF, then back to ON, and
place the car on a clear surface.
Insert new battery or recharged battery.
Switch to same channel.
Switch both car and controller off and allow the car to cool down for
about 30 minutes.
First turn on the transmitter, only then the vehicle.
Extend the antenna fully.
Change the frequency in both vehicle and controller.
11
When the controller is switched on,
the red LED lamps at the front of the
controller are lit.
When the control LED flashes, the
9-volt battery in the controller must be
replaced.
Steering digital proportional
Gas pedal to the rear: forwards
Gas pedal to the front: braking,
or backwards.
TH-TRIMM
Fine speed regulation
Here you can adjust the braking effect
on your vehicle.
TRIMM-steering
Fine steering adjustment
If the vehicle does not run in a straight
line, you can make fine steering adjust-
ments here.