Thitronik Pro-finder Instructions De Service Et De Montage page 29

Pro-finder Manual
1.9 Deleting the destination phone numbers
SIM card must be in the device!!
To delete all destination numbers in memory, proceed as follows:

Disconnect the main cable assembly.

Set the operating mode switch to position E.

Re-connect the main cable assembly
(wait until the status LED flashes yellow / green).

Set the operating mode switch back to the initial position.

The memory is now empty and can be reprogrammed
with a new programming SMS.
The memory can also be overwritten by the master number,
without setting the operating mode switch.

To do this, you must send a programming SMS to Pro-finder
as described in chapter 1.8.
1.10 Display of the operating states (Status LED)
Flashes red / yellow:
Flashes red:
Flashes green:
Illuminated red:
Flashes red / green:
Flashes yellow:
Flashes yellow / green:
Illuminated green:
Illuminated yellow:
After completion of the installation and programming, the status LED flashes
green in normal operation.
Network search + no destination phone numbers entered
Network search / no GSM reception
Logged in (reception) + destination phone numbers entered
SIM card is missing or defective
PIN is not 0000
Destination phone number memory is empty
No destination phone numbers entered + logged in
Pro-finder is sending an SMS
Establishing contact with modem
Page 9