Thitronik Pro-finder Instructions De Service Et De Montage page 26

Pro-finder Manual Page 6
1.8 Programming the destination phone numbers
Before you can start programming, a valid SIM card (Micro-SIM) from a mobile
phone provider must be inserted in the module
The PIN for the card that is
used must be changed to 0000
before it is inserted.
The PIN query function must
be activated.
All call forwarding functions
and the mailbox must be
deactivated.
The convenience functions of
the card must be deactivated.
(Callback if busy, reminders
per SMS, etc.)
When the card is inserted Pro-
finder must be de-energised.
The card must be valid for
roaming if it will also be used
in foreign countries.
SIM card used:
In order to use the Pro-finder, you need a SIM card of a mobile phone supplier. We recommend using
a card from T-mobile or Vodafone. However, cards from other suppliers are also generally suitable.
Since pre-paid cards do not result in monthly charges, these cards are ideal for the purpose. The cur-
rent credit on the card is transferred with each SMS. When choosing a pre-paid card, ensure that it
does not need to be removed from the device in order to top up the credit, but that it can be topped
up from another mobile phone, for example from an ATM.
Saving the number of the Pro-finder:
In order to assign the number quickly when there is an alarm message, you should assign it to a name,
as with every other entry in the address book of your telephone. Since you may also need to access
the number quickly, ideally you should label name it ALARM, then it will be stored at the beginning
of your address book. If you write alarm as shown below, it will always be at the top of the list: Alarm.
The number must always be stored with the country code (e.g. +44 for the UK) in order to access
it from abroad.
Controlling by SMS or phone call:
Each SMS sent by Pro-finder results in costs that will depend on your network operator. If you control
the system by SMS or phone call, this always produces a status SMS.