Thitronik Pro-finder Instructions De Service Et De Montage page 27

Pro-finder Manual
1.8 Programming the destination phone numbers
Once the SIM card has been inserted and locked in place the power supply can
be connected. The status LED will now flash red briefly and then will flash yel-
low / green.
Now the programming SMS described below can be sent to the number of the Pro-
finder. If the SMS was received and the numbers were saved, the status LED flashes
green and a status SMS is sent to the sender of the programming SMS. Pro-finder is
now ready for operation.
Destination phone numbers are the phone numbers that will be alerted in case
of an alarm. Up to 10 numbers can be saved.
There are different types of destination phone numbers:
Master number:
Authorised numbers:
Non-authorised numbers:
Smartphone numbers:
The query codes used for pre-paid cards can be found in the following table.
Table – query codes
Provider
e-plus
O2
T-Mobile
Vodafone
Is the phone number at the top of the list when
the destination phone numbers are saved.
This number can program new destination
phone numbers at any time, without access
to the operating mode switch.
These are destination phone numbers that have
authorisation to control the outputs of Pro-finder
via SMS and to request status reports.
These destination phone numbers have no access
to the system functions. They only receive status
messages.
These can be master numbers, authorised
numbers or non-authorised numbers that were
provided with an "s" during programming and
can receive the vehicle position as a link that can
be displayed as a map with any standard smart-
phone.
Query code Provider
*100# Simyo
*101# Tchibo
*100# Swisscom
*100# Information provided without warranty.
Changes by the provider are possible.
Page 7
Query code
*100#
*101#
*130#