When To Change The Dust Compartment Filter (For Motor Protection); How To Change The Dust Compartment Filter; When To Replace The Airclean Exhaust Filter; How To Replace The Airclean Exhaust Filter - Miele Classic C1 Mode D'emploi

 Insert the hose connector into the
suction socket on the vacuum
cleaner until it clicks into position .
When to change the dust compart-
ment filter (for motor protection)
Replace this filter every time you start a
new packet of dustbags. A dust com-
partment filter is supplied with every
packet of Miele dustbags.
How to change the dust compart-
ment filter (dia. 21)
 Open the dust compartment lid.
 Unclip the filter frame and replace the
dust compartment filter.
 Close the filter frame.
 Close the dust compartment lid.
When to replace the AirClean ex-
haust filter
Replace this filter every time you start a
new packet of Miele dustbags. An
AirClean exhaust filter is supplied with
every packet of Miele dustbags.
How to replace the AirClean exhaust
filter (dia. 22)
Do not use more than one exhaust fil-
ter at a time.
 Open the dust compartment lid.
 Release the filter grille and raise it
upwards. Grasp the used AirClean
filter by the clean, unsoiled section
(see arrow) and take it out.
 Replace it with a new filter.
 Close the filter grille.
 Close the dust compartment lid.
Replacing one type of exhaust filter
with another
Depending on model, your vacuum
cleaner may also be supplied with an
Active AirClean 30 or HEPA AirClean 30
filter which can be fitted instead of the
standard AirClean filter.
In order to use either of these filters you
first have to remove the AirClean filter
and the filter grille and replace these
with the new filter. You will also need to
press the exhaust filter change indicator
to activate it (dia. 23).
After approx. 10 - 15 seconds a thin red
line will appear in the left hand side of
the display (dia. 24).
When to replace the Active AirClean
30 / HEPA AirClean 30 filter (dia. 25)
Replace if the display for the exhaust fil-
ter change indicator timestrip is com-
pletely filled with red. This occurs after
approx. 50 hours of operation which is
equivalent to about a year of average
use. The vacuum cleaner can still be
used. However, the suction power will
be reduced as will the effectiveness of
the filter if it is not replaced in good
time.
How to replace the exhaust filter
Active AirClean 30 / HEPA AirClean
30 (dia. 26)
 Lift out the old exhaust filter.
 Replace it with a new filter.
 Press the exhaust filter change indic-
ator (dia. 23).
en
39