Safety Regulations; Putting Into Operation; Maintenance And Cleaning - EINHELL DTA 25 Instructions D'utilisation

Anleitung DTA 25 und DTA-P 40

5. Safety regulations

Take suitable precautions to protect yourself and
your environment from potential hazards.
Never put the stapler to any use other than that
intended.
Keep pneumatic tools safe from children.
Always concentrate while you work. Do not work if
you are tired.
Use only a quick-release coupling to connect up
the air supply.
It is imperative to use a pressure reducer to set
the working pressure.
Never use oxygen or combustible gases as an
energy source.
Always disconnect the tool from the air supply
before carrying out any repairs or maintenance
work.
Use only original replacement parts.
Wear the necessary protective clothing,
particularly goggles and safety gloves, when
working with the stapler.
Do not exceed a maximum pressure of 6 bar.
Never point the stapler at any persons when it is
connected up and loaded.
Do not remove any protective devices or contact
guards.
Never leave the tool unattended when loaded.
Never use defective tools.
Use only original Einhell staples.
When the tool is disconnected it must not be under
any pressure.
Never use the tool without staples.

6. Putting into operation

Screw the supplied plug-in nipple into the air
connection.
To fill the magazine, press on the magazine lever
and pull back the lower magazine shaft as far as the
stop. Insert the staples in the magazine, shoulder
first. With the professional stapler the staples are to
be placed on the magazine rail from above. Never
insert more than one complete stick of staples or the
magazine will be too full and can no longer be
closed. After connecting the stapler to the air supply,
place it in stapling position and pull the trigger lever.
The trigger lever has to be released after each shot.
Be careful not to staple twice in the same place.
13.11.2001 7:38 Uhr
Caution !
If a staple becomes stuck in the piston shaft, first
disconnect the stapler and make sure it is not under
any pressure before you remove the cover plate.
With the magazine open and the rest of the staples
removed you can then take out the jammed staple.
Clean the shaft if necessary and close again.

7. Maintenance and cleaning

Observance of the following maintenance
instructions will ensure that this quality tool gives you
years of troublefree service.
Before starting to work, always check that the
magazine is secure. Clean the tool thoroughly when
you are finished with your work.
Regular lubrication is vital for the long-term, reliable
operation of your stapler. Use only special tool oil for
this purpose.
You can choose from the following options for
lubricating the tool:
7.1 By mist oiler
A complete conditioning unit includes a mist oiler and
is fitted to the compressor.
7.2 By hand
If your air system has neither a conditioning unit nor
a line oiler, you must feed 3-5 drops of special tool oil
into the air connection each time before you use your
stapler. If the pneumatic tool has not been used for
several days, you must feed 5-10 drops of oil into the
air connection before you switch on.
Keep your pneumatic tool in dry rooms only.
The warranty does not cover:
Wearing parts
Damage caused by an unacceptable level of
working pressure.
Damage caused by unconditioned compressed
air.
Damage caused by improper use or unauthorized
tampering.
Seite 5
GB
5