Meaning Of The Leds; Working Instructions; Service And Maintenance - Festool SCA 8 Notice D'utilisation D'origine

TCL 6/ SCA 8
GB
6 Operation
6.1 Commissioning
WARNING
Unauthorised voltage or frequency!
Risk of accident

The mains voltage and the frequency of the pow-
er source must correspond with the specifica-
tions on the machine's name plate.

In North America, only Festool machines with
the voltage specifications 120 V/60 Hz may be
used.
Start charging
Before use, the cable must be completely un-
wound from the recess [1-5].

Insert the mains plug of the charger in the sock-
et.

Push the battery pack [1-2] into the charging
station[1-1].
Wall mounting
See figure [2]
6.2

Meaning of the LEDs

After inserting the charger in the socket, all the
LEDs light up for approx. 1 s (SCA 8 only).
After this, the charge status display [1-4] on the
charger initially changes to the yellow LED ("self-
check") and then indicates the operating condition
of the charger:
Yellow LED- steady light
Charger is ready for operation.
Green LED - flashing
Battery pack is charging.
Green LED - steady light - READY
READY
The battery pack is > 80% charged and ready
for use. In the background, the battery pack
will continue to be charged up to 100%.
Red LED - flashing
General fault indicator, e.g. not in full con-
tact, short circuit, faulty battery pack, etc.
Red LED - steady light
Battery temperature is outside the permit-
ted limit values. As soon as the permitted
temperature is reached, the charger auto-
matically switches to charging.
10
Remaining charge time (SCA 8 only)
> 45 min
30 min
15 min
In addition, the SCA 8 charger indicates the
5 min
maximum remaining charge time on the
LEDs [1-3]:

Insert the battery pack
The charge status display flashes several times.
Maximum remaining charge time is displayed by
the corresponding LED flashing.
6.3

Working instructions

Continuous or several consecutive charging cycles
can cause the charger to heat up. However, this
does not do any harm and does not indicate a tech-
nical fault.
When kept in the charger, battery packs remain ful-
ly charged.
Place battery pack during charging in a well venti-
lated area.
AIRSTREAM (SCA 8 only)
The SCA 8 charger is fitted with a fan and actively
supports cooling of the BP 18 Li-AS battery packs.
7

Service and maintenance

Observe the following instructions:
– Keep the connecting contacts on the charger
clean.
– Do not cover the vents [1-6] on the SCA 8 charger.
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at: www.festool.com/service
EKAT
Only use original Festool spare parts!
4
Order No. at: www.festool.com/service
5
3
2
1
8 Environment
Do not dispose of the device in house-
hold waste! Recycle devices, accesso-
ries and packaging. Observe applica-
ble national regulations.
EU only: In accordance with European
Directive on waste electrical and electronic equip-
ment and implementation in national law, used
electric power tools must be collected separately
and handed in for environmentally friendly recy-
cling.
Information on REACh: www.festool.com/reach