Messages
If the following messages flash in the display window, check the messages below.
Error message Meaning/Remedy
BLANKDISC
BUSY
Data Save
DISC FULL
Hi DC in
HOLD
LOW BATT
MEM OVER
NAME FULL
NO BATT
NO COPY
NO DISC
• An MD with no recording on it is inserted.
• You tried to operate the recorder while it was accessing the recorded
data.
, Wait until the message goes out (in rare cases, it may take a few
minutes).
• The MD player is recording information (sounds) from the memory
to the disc.
, Wait until this process is completed. Do not expose the player to
any physical shock, nor disrupt power supply.
• The remaining recording time on the disc is 12 seconds (stereo), 24
seconds (LP2 stereo or monaural), 36 seconds (LP4 stereo), or less.
, Replace the disc.
• Voltage of the power supply is too high (The supplied AC power
adaptor or the recommended car battery cord is not used).
, Use the supplied AC power adaptor or the recommended car
battery cord.
• The recorder is locked.
, Slide HOLD against the arrow to unlock the recorder (page 58).
• Battery is weak.
, Charge the rechargeable battery or replace the dry battery
(page 15).
• You tried to record with the recorder placed where it receives
continuous vibration.
, Put the recorder on a stable place, and start recording again.
• You tried to enter more than 200 letters to label a single track or disc.
• You tried to enter a total of more than 1700 letters for track or disc
names.
, Enter a shorter name for the track, group, or disc (page 47), or set
the "LP Stamp" setting to "Stamp OFF" so that "LP:" is not
added at the beginning of the track name (page 28).
• The rechargeable battery is not inserted.
, Insert a rechargeable battery.
• You tried to make a copy from a disc that is protected by the Serial
Copy Management System. You cannot make copies from a digitally
connected source which was itself recorded using digital connection.
, Use analog connection instead (page 27).
• You tried to play or record with no disc in the recorder.
, Insert an MD.
73
-GB