• If the fuse is blown again after it is replaced, contact your nearest Sony dealer. When visiting the
dealer, take the defective fuse with you.
Playing an MD within your car stereo system
1
Turn down the volume of the car cassette deck.
2
Set the tape selector to the normal (TYPE I) position and the DOLBY NR, REPEAT or
BLANK SKIP switch to OFF (if your deck is equipped with these swithes.)
3
Insert the car connecting pack into the cassette deck.
4
Start playback on the car cassette deck.
5
Start MD playback.
6
Adjust the volume.
If no sound is heard or the car connecting pack is ejected, change playback direction on the
car cassette deck.
To remove the car connecting pack, press the Z (eject) button of the car cassette deck.
Notes
• Never insert the cord end of the car connecting pack into the cassette insertion door. If you do, the
cord may break or the car cassette deck may be damaged.
• The car connecting pack may with some car cassette deck.
• The cord should be placed so that it does not hinder driving.
• To disconnect the cord from the player, pull it out by grasping the plug. Never pull the plug out by the
cord.
• With some car cassette decks, you may hear some rattling noise from the car connecting pack.
However, this is not a sign of malfunction.
• Sony guarantees only playback operations on the recorder during use with the car connecting pack.
Recording or charging operations are not guaranteed and should not be attempted.
46
-GB