Removing And Fitting The Battery; Fitting The Battery; Removing The Battery; Switching The Trimmer On/Off - Stihl FSA 60 R Notice D'emploi

English
a
3
► Undo the screws (2).
► Move the loop handle (1) to the required position and
check that the following conditions are met:
– The bump guard (3) fits between the loop handle (1)
and the control handle.
– a = no more than 30 cm.
► Tighten down the screws (2) so that the loop handle (1)
cannot be rotated on the shaft.

9 Removing and Fitting the Battery

9.1

Fitting the Battery

2
1
48
1
2
3
► Insert the battery (1) in the battery compartment (2) and
press it home until you hear a click.
Arrows (3) on battery (1) are still visible and battery (1) is
held securely in battery compartment (2). There is no
electrical contact between the trimmer and battery (1).
► Push the battery (1) into the battery compartment (2) as
far as stop.
The battery (1) engages with a second click and is flush
with the trimmer's housing.
9.2

Removing the Battery

► Stand the trimmer on a level surface.
► Hold one hand in front of the battery compartment to
ensure the battery does not fall out.
2
► Press the locking lever (1) with your other hand.
The battery (2) is unlocked and can be removed.

10 Switching the Trimmer On/Off

10.1 Switching the Brushcutter on

► Hold the brushcutter firmly with one hand on the control
handle – wrap your thumb around the handle.
► Hold the brushcutter firmly with your other hand on the
loop handle or the handle hose such that your thumb holds
the loop handle or the handle hose.
9 Removing and Fitting the Battery
1
0458-832-9621-A