Memory Function; Programming Transmitter - Becker CentronicPLUS EC541 PLUS Notice De Montage Et D'utilisation

Memory function

The memory function can save one switching time for a and run respect-
ively, and repeat every 24 hours.
Whether or not this function is available depends on the devices used and is
described in the relevant instructions for the receiver.
Intermediate position I + II
The intermediate positions I + II are freely selectable positions for the shading
solution between the two limit positions. Each travel button can be assigned
one intermediate position. Both limit positions must be set before an interme-
diate position is set.
Whether or not this function is available depends on the devices used and is
described in the relevant instructions for the receiver.
Installation key
All of the devices operating within an installation must have the same installa-
tion key in order to communicate with one another. This key is created on ini-
tial commissioning, and is then transmitted to the additional added devices.
The installation key is only known to the programmed devices, and cannot be
read off. The commissioning procedure is described in the relevant instruc-
tions for the receiver.

Programming transmitter

Please find the appropriate description in the instructions for the receiver.
21 - en