Kuppersbusch ITE1260-1 Notice D'utilisation page 23

On the opposite side:
1. Tighten the lower pin.
2. Install the spacer.
3. Install the door.
4. Tighten the upper pin.
Ventilation requirements
The airflow behind the appliance must be
sufficient.
min.
200 cm
Installing the appliance
Caution! Make sure that the mains
cable can move freely.
Do the following steps:
1. If necessary cut the adhesive sealing
strip and then apply it to the appliance
as shown in figure.
x
2. Install the appliance in the niche.
Push the appliance in the direction of
the arrows (1) until the upper gap cover
stops against the kitchen furniture.
Push the appliance in the direction of
the arrows (2) against the cupboard on
the opposite side of the hinge.
2
min.
200 cm
2
x
23